
Thermal Insulation
When Does a Building Need Thermal Insulation?
You do not need to wait until indoor temperatures become extremely uncomfortable. Several signs may indicate that the roof insulation system should be assessed, including:
- Noticeably high temperatures on upper floors during the daytime.
- Air-conditioning systems running for long periods to reach the desired temperature.
- Rooms heating up quickly after the air conditioning is switched off.
- A concrete or metal sheet roof exposed directly to sunlight.
- A new building where heat transfer needs to be reduced before occupancy.
How Do We Determine the Right Thermal Insulation System Before Installation?
We do not select the insulation material before inspecting the site. The assessment starts by identifying the roof type, area, condition, and exposure to weather conditions, followed by inspecting any areas that require repair or preparation before installation begins.
During the inspection, we also determine the required performance of the system, the appropriate insulation material, the proposed thickness, and how the insulation layer should be protected after installation.
This step is important because insulation performance does not depend solely on the material name or density. It is also affected by thickness, thermal conductivity, roof characteristics, installation quality, and the continuity of the insulation layer.
Roof Thermal Insulation Installation Process
Once the appropriate system has been approved, installation follows a clear sequence to avoid applying insulation over an unprepared surface.

Roof Inspection
We identify the roof type, whether concrete or metal sheet roofing, and inspect its condition before starting work.

Preparing the Work Area
The roof is cleaned of dust, debris, and any materials that could affect system adhesion, while defects requiring repair are addressed.

Preparing Metal Sheet Roofs
When working on metal sheet roofing, the condition of the sheets is inspected, existing issues are addressed, and the surface is prepared before applying the foam.

Checking Surface Dryness
Spraying does not begin until the roof condition is confirmed to be suitable for the selected system.

Applying the Foam
The foam is sprayed systematically to achieve the specified thickness according to the approved project requirements.

Inspecting the Insulation Layer
After application, the insulation layer is inspected for continuity and consistent thickness, and any areas requiring additional treatment are completed.

Protecting the Foam Layer
A suitable protective coating is applied according to the selected system. This may include an acrylic-based elastomeric coating when approved for the project, helping protect the insulation layer according to the roof’s exposure to weather conditions.

Final Inspection
The completed coverage is reviewed to confirm that the work has been properly completed before the site is handed over.
Frequently Asked Questions About Thermal Insulation
There is no single material that can be considered the best for every project. The correct choice depends on the roof type, required performance, application method, thickness, and material properties. This is why an inspection is carried out before a system is recommended.
Polyurethane foam can be used in suitable applications, but surface preparation and installation methods differ depending on whether the roof is concrete or metal sheet roofing.
Reducing heat transfer into the building can lower the thermal load handled by the air-conditioning system. The actual impact varies according to the building, insulation system, cooling efficiency, and usage conditions.
Yes. Thickness is one of the factors affecting thermal performance and should be specified as part of the insulation system together with material properties, thermal conductivity, and application quality.
The roof must be inspected first. If defects or unsuitable areas are found, they must be repaired and the surface properly prepared before installing the new system.
